The Tru-BoostX Boost Controller Gauge delivers all of the features you loved about the original only now with AEMnet for data logging and a big, fat internal MAP sensor that can handle boost pressures up to 80 PSI of boost. The King is dead, long live the King!
The Tru-BoostX Boost Controller gauge delivers digital accuracy but with the simplicity of a manual boost controller. All programming is done using the faceplate buttons and no laptop is required. AEM’s specially designed Boost Control Solenoid and all necessary hardware is included.
*Program Two Boost Levels + Scramble Boost Setting* - Program two boost modes for different levels of performance (up to 80PSIg internal MAP sensor), and program a time-based scramble boost setting that is controlled using a switched input. You can also turn off the controller and use the gauge as a display.
*Change Wastegate Open Pressure* - Ideal for reducing boost spikes and improving spool up.
*Display Boost Levels in PSIg (PSI), BAR or kPa (PAS)* - See your boost in the units you prefer, and scale the 24 outer LEDs to match your peak boost levels for the perfect sweeping motion.
*Set Alarms and Display Peak Boost* - Set the 24 green outer LEDs to flash based on boost pressure so you are alerted to an overboost condition. A ground output is included for triggering an optional LED warning light. Select the “B” button to see peak boost level and clear the value using the menu.
*Overboost Protection Built In* - Protects your engine from an overboost condition by shutting the boost control solenoid off until it is reactivated by you through the buttons on the faceplate.
*Integrated Error Protection* - Alerts you to a fault if the boost control solenoid is shorted or disconnected so you are never left guessing whether the Tru-BoostX is operational.
*Datalog using AEMnet CAN bus* - Outputting channels over AEMnet provides so much more than just boost pressure! Send 13 channels of data over a 2-wire connection, including boost pressure, peak boost, boost target, boost scramble duty, overboost status, wastegate crack pressure, boost control solenoid status and more.
*Tru-BoostX Gauge Features:*
* A boost display gauge and boost controller in one!
* Easy to program – no laptop required
* Boost control solenoid and all necessary hardware included
* On-board 80PSIg MAP sensor—no upgrade kit needed for high boost vehicles
* Two boost level settings and scramble boost setting
* Wastegate open pressure setting for controlling boost spikes and faster spool
* Display boost levels in PSI, BAR or kPa
* Overboost protection and programmable alarms, ground output for optional LED warning light
* Peak boost level recall
* X-Series design for the best visibility (87% larger center LED and 33% larger face design)
* X-Series dimensions make it easier to install (0.825” overall depth, 0.20” cup depth)
* AEMnet CAN bus enabled for data logging (13 channels of data over 2-wire connection)
* Standard 52mm (2-1/16”) cup
* 24 programmable green outer LEDs
* Auto dimming sensor for ideal brightness day or night
* Positive locking connectors
* Optional silver bezel with white faceplate accessory kit (30-0352-ACC)
