Home > BP Store > 90-99 DSM > Drivetrain & Clutches >

Driveshaft - Driveshaft Shop Carbon Fiber Driveshaft (2G DSM AWD - 25 Spline Yoke)
Driveshaft  - Driveshaft Shop Carbon Fiber Driveshaft (2G DSM AWD - 25 Spline Yoke)


 
These are Driveshaft Shop's 950HP 3.5" Heavy Duty Carbon Fiber drive shafts for the Eclipse and Talon. This shaft is designed to replace the first 2 shafts of the factory 3-piece system. They were going to try to make a single shaft but due to Critical speed limitations it would need to be 4" in diameter and would not fit under the car and also the operating angles would not allow for a 1-piece shaft to work. The front angle was 2 degrees and the back was 7 degrees (not good), the problem is the rear joint would move more than 2 times as much as the front and cause a very nasty vibration. The AE-7 manual of Automotive engineers doesn't recommend any driveshaft to have more than a 1 degree difference from one operating angle to the other (this would be a 5 degree spread). This shaft comes complete with a conversion plate for the CV end and all hardware to make this a job that can be done in the garage. This Heavy Duty shaft is rated for 950HP.

Please note that this driveshaft is designed for use with the 25 spline yolk for the Shep transfer case upgrade.

**Photo is representative; may not be actual product.
Our Price: $1,259.99

Availability:: Usually Ships in 2 to 3 Business Days
Product Code: DSS-CF-DS-2G


Diameter:


Qty:  
Description
 
These are Driveshaft Shop's carbon fiber drive shafts for the 2G DSM. This shaft is designed to replace the first 2 shafts of the factory 3-piece system.  Rated for 950HP.

Share your knowledge of this product. Be the first to write a review »